We Are Proud To Sell Ricochet Skid Plates. Best Prices On The Net. The Best Protection For Your ATV, Period!
From www.atvpt.com  Can-Am Renegade 800
Complete Skid Plate Set (p/n
6678)
Features:
All
of the Ricochet products are made of 3/16" extruded aluminum and have a clean,
quality finish.
Comes with supplied hardware, including
round-headed Allen bolts that resist damage when scraping along
the rocks on the trail.
Installation:
Installation was
not difficult at all. I was expecting some “force-fit” requirements,BUT there
weren’t any.
1. Standing the ATV up on the rear grab
bar will make the installation easier. Use a rag or cardboard to protect your
grab bar. Remember to keep your bike anchored so it will not fall when you are
working on it.
2. Remove the factory front bash plate,
this is the aluminum piece that starts just behind the front bumper,
approximately 16” long.
1
3. Attach the Ricochet front skid plate
and tighten.
4. Attach the rear skid plate, DO not
tighten at this time.
5. Install,but DO not tighten the
floorboard brackets.
Hold the floorboard skid plate in
position and look for interference with the front or rear skid plates, adjust as
required. The rear skid plate has slots for
adjustment.
1
6. Tighten the rear skid
plate.
7. Hold the floorboard skid plate in
place to check location of these attach points. Move the floorboard
brackets as required to align with the holes
in the floorboard skid plate and tighten. Attach floorboard skid
plate.
8. Drill the rivets out of the factory
A-arm guards using a ¼” drill bit. Position the Ricochet A-arm guards and
attach the clamps to them, but DO not tighten.
NOTE: This next step is very important,adjust
the A-arm guards to provide clearance between the outer axle shaft boot and the
aluminum guard. This clearance MUST be as much as
possible.
Installed.  |
